polargraph_arduino/libraries/AccelStepper/examples/Overshoot/Overshoot.pde

29 lines
751 B
Plaintext

// Overshoot.pde
// -*- mode: C++ -*-
//
// Check overshoot handling
// which sets a new target position and then waits until the stepper has
// achieved it. This is used for testing the handling of overshoots
//
// Copyright (C) 2009 Mike McCauley
// $Id: Overshoot.pde,v 1.1 2011/01/05 01:51:01 mikem Exp mikem $
#include <AccelStepper.h>
// Define a stepper and the pins it will use
AccelStepper stepper; // Defaults to AccelStepper::FULL4WIRE (4 pins) on 2, 3, 4, 5
void setup()
{
stepper.setMaxSpeed(150);
stepper.setAcceleration(100);
}
void loop()
{
stepper.moveTo(500);
while (stepper.currentPosition() != 300) // Full speed up to 300
stepper.run();
stepper.runToNewPosition(0); // Cause an overshoot then back to 0
}